Wartie Advanced Wart and Verruca Remover - 50ml (A)

Wartie Advanced Wart and Verruca Remover - 50ml

How to use

Please read the enclosed leaflet carefully before using this product.

Common Warts:

Gently squeeze the gel tube to apply one single drop of the conductive gel exactly on the wart.

Remove the cap and place the can upright on a table or flat surface.
Keeping the can in vertical position (do not tilt); firmly hold the collar between your thumb and index finger, twist the cone in counter clockwise direction with your other hand and firmly push down the cone for 3 seconds without touching the metal tip. You will now hear the activation sound (hiss).
Be sure the cone twists back to zero automatically to lock the system before applying the product. Wait for 2 seconds while the metal tip freezes.
Precisely apply the frozen metal tip on the common wart (hand) for 20 seconds.

Plantar Warts (verrucas):

Gently squeeze the gel tube to apply one single drop of the conductive gel exactly on the wart.

Remove the cap and place the can upright on a table or flat surface holding it by the collar.
Keeping the can in vertical position (do not tilt); firmly hold the collar between your thumb and index finger, twist the cone in counter clockwise direction with your other hand and firmly push down the cone for 3 seconds without touching the metal tip. You will now hear the activation sound (hiss).
Be sure the cone twists back to zero automatically to lock the system before applying the product. Wait for 2 seconds while the metal tip freezes.
Precisely apply the frozen metal tip on the plantar wart (foot) for 40 seconds.
In case of particularly sensitive skin (i.e. if you experience difficulties walking after treatment), a foam plaster can be used to protect the tender plantar wart area after treatment has been completed. Carefully remove foam plaster from backing. Apply adhesive side of foam plaster to skin with hole directly over the small tender spot.

It is important that the instructions in the information leaflet are followed exactly. Careless use can cause freezing too deeply, causing permanent damage to the uppermost layer of the skin on fingers and toes. This may result in permanent scarring or nerve damage.

Follow-up treatment

• Keep the treated area clean.
• You may swim or shower.
• Do not pick or scratch the treated area as this may result in infection.
• Protect blisters, if necessary, with a gauze or sterile adhesive bandage.
• Do not puncture blisters. Puncturing blisters will be painful and may result in infection.
• Avoid sun exposure or wear sunscreen (SPF 30 or higher) and minimize trauma to treated sites until completely healed (i.e wart/verruca has fallen off and colour has returned to normal).

Hazards and Cautions

Before you use this product

Contains small parts.

Keep out of reach and sight of children.

The metal tip is coated with nickel.

Avoid contact with eyes.

Do not swallow.

For external use only.

Do not use this product:

• on children under the age of 12
• if you are diabetic or suffer from poor circulation
• if you are sensitive to one or more of the ingredients.

Always read the enclosed leaflet before using the product.


Storage

Do not expose to temperatures exceeding 50°C/122°F. Protect all devices from sunlight and store in a cool dry place.

Pressurised container: may burst if heated. Do not pierce or burn, even after use.

Keep away from heat/sparks/open flames/hot surfaces - No smoking.

Do not spray on an open flame or other ignition source.

 

Ingredients

Aerosol can Ingredients: Dimethyl ether

Conductive gel tube Ingredients: Aqua, Propylene Glycol, Phenoxyethanol, Carbomer, Triethanolamine, Caprylhydroxamic Acid, Methylpropanediol